Powered Subwoofer Basslink II
POWER CONNECTIONSAPPLICATIONS
Make Power, Ground and Remote turn-on Y Install a fuse holder with a 25A fuse within 18"BassLink II is equipped with four line-level (RCA)To help you plan your installation, we have
connections as shown in Figure 5. Observe of the battery + terminal (see Figure 5).inputs and four speaker-level inputs. Any combina-included three system applications in Figures 6
the following installation tips:tion of line-level and speaker-level inputs may bethrough 8. For more system ideas, see your
Y The REM connection requires +5 to +12 Vdc used to provide nonfading bass when connected toauthorized Infinity car audio dealer.
Y Use #8 AWG wire for the +BATT (+12Vdc) for BassLink II to turn on remotely. Most heada head unit with four outputs.
and GND (ground) connections. If needed, useunits with preamp outputs provide this remoteNote: The applications show the REMOTE LEVEL
at least a #20 AWG wire for the REM (remote)voltage signal. For speaker-level applications, Figure 6. BassLink II audio connections for a headcontrol, which installs under the dashboard for
connection.a remote connection is not required, sinceunit with two line-level or subwoofer (RCA) outputs.easy in-car bass level adjustments (see page 7).
BassLink IIOs AutoTurn On feature will sense
Y If you pass the power or remote wire voltage on the speaker wires to automatically
through the vehicleOs firewall or other metalturn on BassLink II.
obstruction, it must be insulated with a rubber
grommet. If a factory-installed grommet isIMPORTANT: To enable BassLink IIOs Auto
unavailable, be sure to install a rubber Turn On feature, set AUTO TURN ON to the
grommet to protect the wires.AUTO position (see Figure 15 on page 6).
Y Connect a short GND wire from BassLink II to
the nearest bare metal surface. For a good
connection, sand away paint from the metal
surface and use a screw with a (star) lock washer.
Figure 5. Power connections for BassLink II.
¨
3 |
ACEC
